Pay Attention to Assemble Joyal Cone Crusher

Under the function of the spring, the discharging mouth will be automatically reset and cone crusher machine will resume normal work. This series of cone crusher is divided into three types, namely coarse cone crusher, medium cone crusher and fine cone crusher supplier and the customers can choose different type according specific needs.

Performance Features of China Cone Crusher : When some foreign matters that cannot be crushed go into the crushing chamber or the machine is overloaded due to some reasons, the spring protection system of China cone crusher will increase the discharging mouth and the foreign matters will be discharged from the crushing chamber, thus realizing protection. If the foreign matters are stuck at the discharging mouth, the spring protection system will start the chamber cleaning system and continue to increase the discharging mouth, so that the foreign matters can be discharged from the crushing chamber of cone crusher manufacturer.

1. Cone crusher and the spherical bearing spherical bearing installation

Spherical axis of the rack, the spherical bearing with a cylindrical pin is fixed to the bearing housing, in order to prevent the cylindrical pin loosening, the need to water of zinc alloy. Lifted in the repair of broken or cone, due to pin loosening, lubricating spherical bearing may be glued to the bottom of the spherical mobile crushing equipment. This cone breaker in the lifting process, the spherical bearing may fall at any time to cause an accident. Spherical bearing installation, it should be closely located in the crusher frame groove of boring, and to key into the groove does not skew fixation, to prevent the bearing groove in the boring swing deflection, and checked with a feeler level close contact situations.

2. Hydraulic cone crusher installation and commissioning

The rock cone crusher should be installed in position for easy operation, push cylinder lock cylinder and corresponding to the oil phase should be to ensure that the forward and back simultaneously push cylinder, hydraulic parts installed, should be the pressure test, test pressure 14Mpa. Pressure in the test process, through the bottom of the pipe and the accumulator block screws, lock cylinder in the pipeline and the residual gas excluded.

3. Cone crusher adjustment device and the installation of locking spring

Installation should be first installed in the lock cylinder on the support ring, and then pay support ring mounted on the rack, and check the slope exposure is uniform, then the adjustment ring screwed into the support ring and lock nut in adjustment ring and align the support ring on the four pin holes, re-positioning of pretty nails. Spring installation is a rough double-detailed work that can not be sloppy, to be consistent all spring compression, the compressed spring height should be consistent with requirements of the drawings, each spring bolts required to install the two nuts.