Suggestions of Limestone crusher configuration

Limestone is easy to break the material, one is low hardness (4 to 5), the second is the silicon content is very low. Therefore, the limestone as raw material of the stone factory production costs are much lower. Therefore, the limestone crushing production line we can directly use the jaw broken counterattack break the program, both to get a good stone grain, crusher parts can also have a very long life. Usually, a pair of jaws used for a year or two is very normal.

Another factor we also need to consider, because the limestone is relatively easy to break the performance, the use of broken broken broken will produce more powder. This is due to the impact crusher is the impact of crushing the characteristics of the decision. If the customer's market demand for stone grain is not high, you can use two-stage jaw crusher way to reduce the proportion of powder, but also relatively reduce the cost of some investment. The specific process of scheduling, according to the customer's actual situation after the analysis to determine.



Due to the easy crushing characteristics of limestone, cement plants with limestone as the raw material are usually crushed by a composite crusher. Using composite crusher directly on the limestone head broken, broken after the particle size can reach 10 to 20 mm below. This is broken in order to break the limestone as small as possible to a smaller particle size, regardless of grain problems. At the same time, such a broken way will produce a lot of powder, for the construction of stone-based stone factory, this broken way inappropriate.

If the customer can accept the powder, then the use of a crusher to be able to complete all the crushing operations is also a good choice.